Page 1 of 1

Gresley a1/3 or 4 radius rod drawing sought

Posted: Mon Oct 11, 2021 12:16 pm
by greenglade
Morning all,

As some will be aware I am building a 5 " model of a Gresley A1 to Don Young's design and I wonder if anyone can help me with a work's drawing for the A1/3 or 4 radius rod? Don's drawing does not follow full size around the knuckle which the expansion link slides into, I'd like to see if I can make mine more prototypical. I took some close-up photos of FS in 2016 and it was one of these which has alerted me to the difference. I have further confirmed this with photos from SNG's overhaul and a very small drawing of the motion from the 1924 Wembley EX booklet which clearly shows the knuckle to be 'offset'. I'm not sure yet if it's possible to include the proper shape as it may not fit but if I can I shall., I will, of course, keep the all-important CTS as drawn by Don between the combination lever and expansion link.

Pete

Re: Gresley a1/3 or 4 radius rod drawing sought

Posted: Wed Oct 13, 2021 5:25 pm
by john coffin
Pete, I have just come in to possession of a couple of drawings which might help.

pm me and I we can discuss how we can proceed to get them to you , to see if they are of use

Paul

Re: Gresley a1/3 or 4 radius rod drawing sought

Posted: Wed Oct 13, 2021 5:33 pm
by greenglade
Thanks John

PM sent..

Pete

Re: Gresley a1/3 or 4 radius rod drawing sought

Posted: Mon Oct 18, 2021 10:16 pm
by greenglade
thank you for all of your help, sir....:)