having finally figured out the whole set up of the Conjuguated gear on the P1, i have built that (though not 100% correct its as close as i can get it)
my next question is; The P1 had the same cylinders as a A1/A3 would this mean they sounded the same? as i intend to alias the sounds to the Blue Arrow TS A3 sounds.
Below is a few Screenshots of Progress, any of you who remember my original post about the P1 Train Simulator model(if you are MSTS drivers) i was originally building will be pleased to know that i started again and have been using drawings as a backdrop so the model should be more correct this time
Although the valve gear and cylinders are similar to the A1, don`t forget that the P1 wheels are only 5`diameter as opposed to the A1 6`8", therefore the exhaust beats should be that much faster for a given speed.
