3D design GNR 6w full brake

[mistahjim]

So I’m actually doing something worth posting, now that time isn’t as critical and other interests have taken a back seat.

For the un-initiated, 3D design kits are laser cut card and MDF, with 4 layers building up the sides and ends. This gives a neat way of building up surface detail like beading. The disadvantage is of course the card sides and the need to paint it. They include practice layers to practice alignment, and I’ve used these to practice painting. The colour is intentionally dark, but I’m open to feedback. The sides and ends are currently under construction.

[Dave]

Over on the dark side, Mike Trice did a very good in depth build on these carriages.
Can't remember when but I will confirm tomorrow when I get to work and look in
My internet favourites.

[Atlantic 3279]

http://www.rmweb.co.uk/community/index. ... =diagram3d

and

http://www.rmweb.co.uk/community/index. ... oaches-oo/

could both be helpful if you've not already seen them.

[Dave]

They are the ones Atlantic.

[mistahjim]

Thanks both, I’ll take a look. I don’t often venture over there unless I’ve a modern image question, and mostly now I’ll put it on the Facebook groups I’m a part of. Progress on 2 other LNER projects to follow as well.